Another day an other door
Took another month off before moving onto the drivers door.
Cleaned up running board mounting area. No holes, just a bit of surface rust
Inspected door edge. There is a small hole on inner and a area around the seal area. Decided not to drag out the welder this time and will do a full skin repair at a later date.
Thinners eats the gloves and eats my skin!
Had again to wipe off all the crap old acrylic paint and barrier coat flat down
Masked up and epoxy primed.
Primer flat sanded and Masked up again. 3 coats of color applied
Not a bad finish. no runs a bit of orange peel and a rough over spray.
Easy two days.....
Moving onto the roof & windscreen in next updates.
No comments:
Post a Comment